Home Code Nucleo-F334 and OLED display

Nucleo-F334 and OLED display

by shedboy71

This is an example of connecting a 128×64 I2C OLED display to a NUCLEO-F334R8.

Vcc – 3.3v
Gnd – Any Gnd
SDA – D14
SCL – D15

here is a picture of the OLED I used, there are many variants of this available

oled 12864 display

oled 12864 display

Schematics and Layout

nucleo and oled schematic

nucleo and oled schematic

 

Now for the breadboard layout

nucleo and breadboard layout

 

Code

This example requires the Adafruit_Gfx library to be imported into your project. Since this is an I2C display and its a 128×64 I had to modify the rawHeight parameter in the Adafruit_SSD1306.h code as follows

Here is an export of the code and libraries

Nucleo_OLED_zip_nucleo_f334r8

Adafruit_SSD1306_I2c(I2C &i2c, PinName RST, uint8_t i2cAddress = SSD_I2C_ADDRESS, uint8_t rawHeight = 32, uint8_t rawWidth = 128)

to

Adafruit_SSD1306_I2c(I2C &i2c, PinName RST, uint8_t i2cAddress = SSD_I2C_ADDRESS, uint8_t rawHeight = 64, uint8_t rawWidth = 128)

[codesyntax lang=”cpp”]

#include "mbed.h"
#include "Adafruit_SSD1306.h"

DigitalOut myLed(LED1);
I2C i2c(I2C_SDA, I2C_SCL);

Adafruit_SSD1306_I2c oled (i2c, D4);

int main() 
{
int tickTime = 1000;
oled.begin(SSD1306_SWITCHCAPVCC);
wait_ms(200);
oled.splash();
oled.display();
wait(2);
while(1) 
{
myLed = !myLed;
wait_ms(tickTime);
}
}

[/codesyntax]

You should see the adafruit logo on your display if everything works OK
Links
STM32 Board Nucleo NUCLEO-F334R8 STM32F334R8 STM32 Development Board Integrate ST-LINK/V2-1 Debugger/Programmer Support Arduino

0.96″ Inch Yellow and Blue I2c IIC Serial 128×64 Oled LCD Oled LED Module for Arduino Display 51 Msp420 Stim32 SCR

Share

You may also like